If no power to yellow wire, check if you get power to red/ white wire.----------
The blower motor is the cause.
If you have power to the red/white and not to the yellow the blower motor has failed or the connector to the blower motor is not making contact, Try this backprobe the yellow wire when you test it and take a pin, paperclip or needle to slide along the wire so you can leave it pluugged in.
If you have power to the yellow wire with the blower switch in the high position and the blower motor does not run then the switch has failed.
To remove the blower switch pull out the ashtray and remove the two screws behind the ashtray. There are two more screws that are under the lip of the trim plate. Remove the screws and pull out on the bottom of the trim and work the top out with the vents included. Be careful not to crack the trim.
The HVAC controls are mounted with four screws and have commectors on the back, remove those and the blower switch can be replaced without replacing the entire assembly.
No comments:
Post a Comment