@

max

Thursday

how to replace Oil Pan on 1999 Chrysler 300M?


Oil Pan


Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions section.
  2. Drain the engine oil and remove the oil filter.
  3. Remove or disconnect the following:

    Negative battery cable
    Dipstick and housing
    Structural collar from the rear of the oil pan and transmission housing
    Engine oil cooler lines from the oil pan, if equipped
    Transmission oil cooler line clips, if necessary
    Oil pan mounting bolts, oil pan and gasket
  4. Clean the oil pan and all gasket surfaces.
To install:
Click image to see an enlarged view
Fig. Exploded view of the oil pan removal and installation-2.7L and 3.5L engines


Click image to see an enlarged view
Fig. To ensure a proper seal, apply sealer as shown-2.7L and 3.5L engines
  1. Apply a 1 / 8 in. (3mm) bead of sealer at the parting line of the oil pump body and the rear seal retainer.
  2. Install or connect the following:

    Oil pan and torque the M8 nuts/bolts to 21 ft. lbs. (28 Nm) and the M6 nuts/bolts to 105 inch lbs. (12 Nm)
  3. Install the structural collar using the following procedure:
    1. Install the vertical collar to the oil pan mounting bolts and tighten, temporarily to 10 inch lbs. (1.1 Nm).
    2. Install the collar-to-transaxle bolts and torque to 40 ft. lbs. (55 Nm).
    3. Starting with the center vertical bolt and working outward. Torque the bolts to 40 ft. lbs. (55 Nm).
  4. Install the dipstick and housing and connect the negative battery cable.
  5. Fill the engine with the proper amount of clean SAE 5W-30 or SAE 10W-30 engine oil only. Do not mix the two grades of oil.
  6. Start the engine, check for leaks and repair if necessary.

-----------
For more car related problem troubleshooting:---

This are the sections, you can go through and click the link to read its troubleshooting.

---------

The car will not start?

-----------------

Car will not crank?


-----------

Car has no spark?


-------------

How to troubleshoot car battery?

-----------------

How to test starter solenoid?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html

--------------------

How to test cars starter?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html

How to replace starter in car?



-----------

car will turn over but will not start?



-----------------

Car wont start?


----------

No comments:

Post a Comment

@