HowToRepairGuide.com: How to Replace Blower Motor on 2008 Honda Odyssey?

The blower motor is located in the front passenger-s right side foot well area.
If additional access is needed, remove the front passenger-s right side lower kick panel.
Detach the electrical connectors from the blower motor.
Remove the fasteners on the blower motor mounting flange.
Remove the blower motor downward from the blower unit.

To install:
Installation is the reverse of the removal procedure.The procedure to replace blower motor is as follows.

Blower Motor

Removal & Installation

NOTE

This procedure requires the use of KTC trim tool set SOJATP2014, or equivalent trim tool set. When removing trim components, wear gloves and be careful not to bend or scratch the trim and panels.

Disconnect the negative battery cable.

Remove the following components, as necessary:

Sliding door sill trim, as needed

C-pillar trim

Sliding door opening trim, as needed

Pull the lower anchor cover back, and remove the lower anchor bolt.

Detach the clip and release the hooks then remove the pivot cover.

Remove the lower anchor bolt.

Remove the rear trim panel (A), as follows:
1. Remove the side bolts (B).
2. Pull out both side edges of the trim panel by hand to release the hooks (C) from the rear side trim panel (D).
3. Pull the trim panel back to detach the clips (E, F).
  
  Fig. Remove the rear trim panel (A) by removing the side bolts (B), releasing the hooks (C) from the rear side trim panel (D) and pulling the trim panel back to detach the clips (E, F)

For the driver-s side, remove the spare tire, as follows:
1. Place a hand in each grab handle on the spare tire cover, and pull back to release the clips. Remove the spare tire cover.
2. Remove the spare tire mounting bolt.
3. Remove the spare tire.

Remove the rear side trim panel, as follows:
1. Remove the cap by releasing the two hooks.
2. Remove the rear side bolt.
3. Pull out the rear upper edge of the trim panel by hand to release the hooks from the D-pillar trim.
4. Pull the trim panel back by hand to detach the clips.
5. Disconnect the accessory socket connectors and the rear entertainment system auxiliary jack connector.
  
  Fig. Rear side trim panel (A) and related components

Disconnect the connectors from the rear mode control motor and the rear blower motor, then remove the wire harness clips, the self-tapping screws and the rear blower motor.

Fig. Disconnect the connectors (A) from the rear mode control motor and the rear blower motor (B), then remove the wire harness clips (C), the self-tapping screws and the rear blower motor

To install:

Installation is the reverse order of removal.

This details will help you.

----------

If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.

For Instructions regarding All types of car heater problem repairs.