How to bleed power steering pump?

It will work well for Mitsubishi car models :----

Bleeding

See below the details :-----

1. Raise the vehicle and support safely.
2. Manually turn the oil pump pulley a few times.
3. Turn the steering wheel all the way to the left and to the right 5 or 6 times.
4. Disconnect the ignition high tension cable and, while operating the starter motor intermittently, turn the steering wheel all the way to the left and right 5-6 times for 15-20 seconds. During bleeding, make sure the fluid in the reservoir never falls below the lower position of the filter. If bleeding is attempted with the engine running, the air will be absorbed in the fluid. Bleed only while cranking.
5. Connect ignition high tension cable, start engine and allow to idle.
6. Turn the steering wheel left and right until there are no air bubbles in the reservoir. Confirm that the fluid is not milky and the level is up to the specified position on the gauge. Confirm that there is very little change in the fluid level when the steering wheel is turned. If the fluid level changes more than 0.2 in., the air has not been completely bled. Repeat the process.

Front

1. Raise the vehicle and support safely.
2. Manually turn the pump pulley a few times.
3. Turn the steering wheel all the way to the left and to the right 5 or 6 times.
4. Disconnect the ignition high tension cable and, while operating the starter motor intermittently, turn the steering wheel all the way to the left and right 5-6 times for 15-20 seconds. During bleeding, make sure the fluid in the reservoir never falls below the lower position of the filter. If bleeding is attempted with the engine running, the air will be absorbed in the fluid. Bleed only while cranking.
5. Connect ignition high tension cable, start engine and allow to idle.
6. Turn the steering wheel left and right until there are no air bubbles in the reservoir. Confirm that the fluid is not milky and the level is up to the specified position on the gauge. Confirm that there is very little change in the fluid level when the steering wheel is turned. If the fluid level changes more than 0.2 in. (5mm), the air has not been completely bled. Repeat the process.

Rear

1. Bleed the front steering system.
2. Start the engine and let it idle.
3. Loosen the bleeder screw on the left side of the control valve and install special tool MB991230 to the bleeder.
4. Turn the steering wheel all the way to the left, then immediately turn it halfway back. Confirm that air has discharged with the fluid.
5. Repeat Step 4 two or three times as required, to remove all air from the rear system. Stop the engine.
6. Loosen the power cylinder (rear steering gear) bleeder screw about ¹ / ₈ turn and install the same special tool with the rotation prevention metal fixtures to prevent the bleeder from opening more.
7. Start the engine and run to 50 mph to circulate the fluid.
8. Maintain a speed of 20 mph and turn the steering wheel back and forth. Air should be discharged through the tube of the special tool and into the oil reservoir.
9. Repeat until all air is removed from the power cylinder.

See below latest solved car problems :----

How to remove Intake Manifold Tuning Valve?

http://technoanswers.blogspot.com/2012/01/how-to-remove-intake-manifold-tuning.html

CMFI details for GMC vehicles?

http://technoanswers.blogspot.com/2012/01/cmfi-details-for-gmc-vehicles.html

Mazda MPV cranks but will not start?

http://technoanswers.blogspot.com/2012/01/mazda-mpv-cranks-but-will-not-start.html

MAZDA MPV WILL CRANK BUT NOT TURN OVER TO START?

http://technoanswers.blogspot.com/2012/01/mazda-mpv-will-crank-but-not-turn-over.html

Freightliner fl112 fuse box diagram?

http://technoanswers.blogspot.com/2012/01/freightliner-fl112-fuse-box-diagram.html

Car will not turn the ignition to start?

http://technoanswers.blogspot.com/2012/01/car-will-not-turn-ignition-to-start.html

Car only starts when gas pedal is pressed?

http://technoanswers.blogspot.com/2012/01/car-only-starts-when-gas-pedal-is.html

Hyundai coupe f2 hazard fault?

http://schematicsdiagram.blogspot.com/2012/01/hyundai-coupe-f2-hazard-fault.html

Where is the bulb located in glove box?

http://repairhelpcenter.blogspot.com/2012/01/where-is-bulb-located-in-glove-box.html

Additional wiring harness needs to be installed in a brake controller for electric brakes on 2012 Toyota Highlander?

http://repairhelpcenter.blogspot.com/2012/01/additional-wiring-harness-needs-to-be.html

Fail smog test due to gas filter hose?

http://repairhelpcenter.blogspot.com/2012/01/fail-smog-test-due-to-gas-filter-hose.html

Clutch squeaking under hood?

http://repairhelpcenter.blogspot.com/2012/01/clutch-squeaking-under-hood.html

Replace door stay assemblies on Toyota?

http://repairhelpcenter.blogspot.com/2012/01/replace-door-stay-assemblies-on-toyota.html

Acceleration lag problem?

http://repairhelpcenter.blogspot.com/2012/01/acceleration-lag-problem.html

How to Replace rear quarter glass on Toyota Tacoma?

http://repairhelpcenter.blogspot.com/2012/01/how-to-replace-rear-quarter-glass-on.html

Overdrive light in the dash blinks?

http://repairhelpcenter.blogspot.com/2012/01/overdrive-light-in-dash-blinks.html

No pulse to injectors?

http://technoanswers.blogspot.com/2012/01/no-pulse-to-injectors.html

How to bypass immobiliser on Rover 200?

http://technoanswers.blogspot.com/2012/01/how-to-bypass-immobiliser-on-rover-200.html

Hood clear coat peeling off?

http://repairhelpcenter.blogspot.com/2012/01/hood-clear-coat-peeling-off.html

Engine stumbles coming off idle when warm?

http://repairhelpcenter.blogspot.com/2012/01/engine-stumbles-coming-off-idle-when.html

How to Refit Rear seat on Rover 600?

http://repairhelpcenter.blogspot.com/2012/01/how-to-refit-rear-seat-on-rover-600.html

How to replace the speakers on 2011 Ford Edge?

http://technoanswers.blogspot.com/2012/01/how-to-replace-speakers-on-2011-ford.html

How to Remove Rear seat on Rover 600?

http://repairhelpcenter.blogspot.com/2012/01/there-are-3-10mm-bolts-at-back-of-seats.html

Toyota solara rattling in rear?

http://technoanswers.blogspot.com/2012/01/toyota-solara-rattling-in-rear.html

Parking light stay on constantly?

http://repairhelpcenter.blogspot.com/2012/01/parking-light-stay-on-constantly.html

Engine hard to start after gas refill?

http://repairhelpcenter.blogspot.com/2012/01/engine-hard-to-start-after-gas-refill.html

How to replace wheel bearing on Honda Civic?

http://repairhelpcenter.blogspot.com/2012/01/how-to-replace-wheel-bearing-on-honda.html

Do snow tires go on the back or front?

http://howtobyme.blogspot.com/2012/01/do-snow-tires-go-on-back-or-front.html

Where is Key chip memory located on 2004 ford Freestar?

http://technoanswers.blogspot.com/2012/01/where-is-key-chip-memory-located-on.html