How to replace Climate control unit on Mazda Protege?

Its not very hard.Go through the procedure with details and diagram to complete this task.

REMOVAL

1. Disconnect the negative battery cable.
2. Disconnect the air mix and airflow mode wires from each wire clamp and link.
3. Remove the center panel.

1. Remove the screws and the climate control unit.

INSTALLATION

1. Install the climate control unit to the center panel.

Pass each wire through the following routes then connect to each unit.
Connect the climate control unit connectors.
Install the center panel.
Adjust the climate control unit wire.
Connect the negative battery cable.

This will help.
Thanks.

See below latest solved car problems :----

How to replace Blower motor resistor on 2001 Mazda Protege?

http://howtobyme.blogspot.in/2012/02/how-to-replace-blower-motor-resistor-on.html

Mazda Protege Blower motor wiring diagram?

http://howtobyme.blogspot.in/2012/02/mazda-protege-blower-motor-wiring.html

Mazda blower motor only works on high mode?

http://howtobyme.blogspot.in/2012/02/mazda-blower-motor-only-works-on-high.html