How to Replace 2AZ-FE Engine on Toyota Avalon & Camry?

The details to replace Toyota Avalon And Toyota Camry Engine.
Its procedure for 2AZ-FE engine.
Also 2.4L (2AZ-FE) engine mounting diagram is provided for more help:---

2AZ-FE Engines

1. Before servicing the vehicle, refer to the Precautions Section.
2. Relieve the fuel pressure from the fuel lines.
3. Drain the engine coolant from the cooling system.
4. Drain the engine oil.
5. Drain the transmission fluid.
6. Remove or disconnect the following:
   
   
   Front wheels

   Engine under covers

   Front fender apron seal

   Engine cover sub-assembly

   Battery cables and remove battery

   Air cleaner assembly, brackets and inlets

   Engine stabilizing control rod

   Oil cooler inlet and outlet hoses

   Engine mounting stay and bracket

   V-belts

   Steering gear outlet return tube

   Union to connector tube hose

   Transmission control cable assembly

   Heater inlet and outlet hoses

   Radiator inlet and outlet hoses

   Fuel pipe sub-assembly

   Engine wire from ECU and junction box

   Engine harness from engine compartment junction block

   Alternator wiring and alternator

   A/C compressor (Do NOT disconnect hoses)

   Front exhaust pipe support bracket

   Front exhaust pipe assembly

   Front stabilizer link assembly

   Both front axle hub nuts

   Both front speed sensors

   Separate both outer tie rod ends

   Separate front lower suspension arm sub assembly, both sides

   Drive plate and torque converter clutch setting bolts (6)

   Separate steering intermediate shaft assembly

   Attach engine hoist

   4 bolts and 2 nuts from RH & LH frame side rail plate

   4 bolts and 2 nuts from RH & LH front suspension member
7. Carefully remove the engine assembly

To install:

1. Lower engine and transmission assembly onto the engine compartment
2. Install or connect the following:
   
   
   RH & LH side rail plates; torque large bolt 63 ft. lbs. (85 Nm) and small bolt and nuts 24 ft. lbs. (32 Nm)

   RH & LH front suspension member brace. Torque large bolt to 63 ft. lbs (85 Nm) and small bolt and nuts 24 ft. lbs. (32 Nm)

   Steering intermediate shaft assembly

   Drive plate and torque converter clutch setting bolts. Torque to 30 ft. lbs. (41 Nm).

   LH & RH lower suspension arm sub-assemblies

   LH & RH tie rod assemblies

   LH & RH speed sensors

   LH & RH front axle hub nuts. Torque to 217 ft. lbs. (294 Nm)

   LH & RH stabilizer link assemblies

   Front exhaust pipe assembly

   Front exhaust support bracket

   Fuel pipe sub-assembly

   Transmission control cable assembly

   A/C compressor assembly

   Alternator belt adjusting bar and bracket

   RH engine mounting stay

   Engine stabilizing control rod

   Alternator assembly

   A/C compressor V-belt

   Inspect drive belt deflector and tensioner

   Air cleaner assembly, brackets and inlets

   Verify vacuum hose connections
3. Refill the transmission fluid to the correct level.
4. Refill the engine oil to the correct level.
5. Refill the power steering fluid to the correct level.
6. Refill the cooling system to the correct level.
7. Start the engine and check for leaks.
8. Check and adjust the alignment if necessary. 
   
   
   
   Fig.  2.4L (2AZ-FE) engine mounting

These details will help.

Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html