How to Replace 2GR-FE Engine on Toyota Avalon & Camry?

The details are provided for replacing Toyota engine.Its for Avalon and Camry models.
Also the engine removal diagrams are provided.
Engine mounting bolts locations-3.5L (2GR-FE) engine diagram is also provided.

Go through complete details and diagram:----

1. Before servicing the vehicle, refer to the Precautions Section.
2. Relieve the fuel system pressure.
3. Drain the engine oil.
4. Drain the cooling system.
5. Drain the transaxle oil.
6. Remove or disconnect the following:
   
   NOTE

   Matchmark the intermediate shaft and control valve shaft before removing.
   
   
   
   NOTE

   Leave the lines connected and securely hang the compressor.
   
   
   
   
   Negative battery cable

   Front wheel

   Engine under covers

   Right side fender apron seal

   Wiper link assembly

   Outer top cowl panel

   Battery

   Engine appearance cover

   Accessory drive belt

   Coolant overflow tank

   Right side engine moving control rod and bracket

   Air intake assembly

   Fuel supply hose

   Radiator hoses

   Transmission oil cooler hoses

   Heater hoses

   Upper relay block cover

   Right-side front door scuff plate trim

   Right-side side cowl trim

   Right-side lower instrument panel

   ECM wiring and body ground

   Transmission control cable

   Power steering hoses

   Front exhaust pipe assembly

   Halfshafts

   Lower control arms

   Torque converter bolts

   Intermediate steering shaft
   
   
   
   
   Alternator

   A/C compressor
7. Attach the engine to a suitable lifting device.
8. Remove the mounting bolts and nuts from the frame side rail plates and front suspension brace.
9. Carefully remove the engine/transaxle assembly from the vehicle.

To install:

Fig. Exploded view of the engine mounting-3.5L (2GR-FE) engine

Fig. Engine mounting bolts locations-3.5L (2GR-FE) engine

1. Install the engine/transaxle assembly into the vehicle.
2. Install the engine mounting bolts and nuts as follows:
   1. Bolts A and C: 63 ft. lbs. (85 Nm).
   2. Bolts B and D: 24 ft. lbs. (32 Nm).
3. Install the A/C compressor. Tighten the mounting bolts in the sequence shown to 18 ft. lbs. (25 Nm). 
   
   
   
   Fig. A/C compressor mounting bolts torque sequence-3.5L (2GR-FE) engine
4. The remainder of the installation is the reverse order of removal.
5. Refill the transaxle with oil to the correct level.
6. Refill the cooling system to the correct level.
7. Refill the engine with oil to the correct level.
8. Start the engine and check for leaks.
9. Check and adjust the alignment if necessary.

These details will help.

Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html