How to Replace Blend Door Actuator on Ford Edge and Lincoln MKX?

The procedure is similar for both ford and Lincoln car models:-----

The blend door Actuator Removal & Installation For
DRIVER'S SIDE
PASSENGER SIDE DUAL ZONE EATC

Driver's Side

Specific to:

Ford Edge 2008-2009

Lincoln MKX 2008-2009

NOTE

It is not required to install the new LH temperature blend door linkage parts included in the LH temperature blend door actuator service part kit if only the temperature blend door actuator requires replacement and the linkage parts are not broken or binding.

1. For LH temperature blend door actuator and linkage, perform the following:
   1. Remove the 2 lower steering column opening cover bolts.
   2. Detach the lower steering column opening cover.
   3. Disconnect the in-vehicle temperature sensor aspirator hose and electrical connector.
   4. Position the instrument panel wire harness away from the LH temperature blend door actuator.
   5. Remove the 3 LH temperature blend door actuator screws.
   6. Disconnect the LH temperature blend door actuator electrical connector.
   7. Remove the LH temperature blend door actuator.
   8. Manually operate, and inspect the LH temperature blend door linkage for incorrect placement, binding or damage.
2. For the LH temperature blend door linkage only, perform the following:
   1. Detach the 2 retaining tabs and remove the LH temperature blend door linkage.
      
      
      

      

      Fig. Exploded view of the LH temperature blend door actuator

To install:

To install, reverse the removal procedure.

Passenger Side-Dual Zone EATC

Specific to:

Ford Edge 2008-2009

Lincoln MKX 2008-2009

NOTE

It is not required to install the new RH temperature blend door linkage parts included in the RH temperature blend door actuator service part kit if only the temperature blend door actuator requires replacement and the linkage parts are not broken or binding.

1. For the RH temperature blend door actuator and linkage, perform the following:
   1. Disconnect the glove compartment damper from the glove compartment.
   2. Remove the glove compartment.
   3. Remove the RH lower instrument panel insulator.
   4. Remove the RH lower floor console trim panel.
   5. Remove the 3 RH temperature blend door actuator screws.
   6. Disconnect the RH temperature blend door actuator electrical connector.
   7. Remove the RH temperature blend door actuator.
   8. Manually operate, and inspect the RH temperature blend door linkage for incorrect placement, binding or damage.
2. For the RH temperature blend door actuator linkage only, perform the following:
   1. Detach the 2 retaining tabs and remove the RH temperature blend door linkage.
      
      
      

      

      Fig. Exploded view of the temperature blend door actuator-RH, dual-zone EATC

To install:

To install, reverse the removal procedure.

This details will help.

Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html