How to replace Fuel Pressure Regulator on Ford Windstar?

The procedure to replace Fuel Pressure Regulator on ford vehicle is as follows:---


Fuel Pressure Regulator
REMOVAL & INSTALLATION Instructions are as follows:----

1. Properly relieve the fuel system pressure.
2. Remove the vacuum line at the fuel pressure regulator. 
   
   
   
   Fig. Carefully remove the plastic vacuum hose connected to the fuel pressure regulator
3. Remove the regulator retaining screws and discard.
4. Remove the fuel pressure regulator, return seal and O-rings. Discard the seal and O-rings.
   
   
   

   

   Fig. The fuel pressure regulator is sealed to the fuel charging assembly with several O-rings

To install:

1. Clean the gasket mating surfaces thoroughly.
   
   NOTE

   Never use silicone grease to lubricate the O-rings.
2. Lubricate the new fuel pressure regulator O-rings with clean engine oil.
3. Install the fuel pressure regulator using new O-rings, seals and retaining screws.
   
   
   

   

   Fig. Always install the fuel pressure regulator with new retaining screws. Never reuse the old screws
4. Tighten retaining screws to 34 inch lbs. (4 Nm).
5. Install the vacuum line at the fuel pressure regulator.

This details will help.

Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html