How to replace Steering Linkage on Toyota 4Runner?

Steering linkage removal or Tie Rod Ends Replacing procedure.


Removal & Installation
TIE ROD ENDS / Steering Linkage:----

1. Using a tie rod end puller, disconnect the tie rod from the knuckle arm.
2. Place matchmarks on the tie rod end, lock nut and rack end.
3. Loosen the lock nut, remove the tie rod end and lock nut. 
   
   
   
   Fig. Matchmark the tie rod end to the rack end before removing

To install:

1. Screw the lock nut and tie rod end onto the rack end until the matchmarks are aligned. Tighten the lock nut as follows:
   1. 2001-02 Models: to 41 ft. lbs. (55 Nm).
   2. 2003-05 Models: to 65 ft. lbs. (88 Nm).
2. Connect the tie rod end to the steering knuckle. Tighten the nut to 67 ft. lbs. (91 Nm) and replace the cotter pin.

These details will help.

Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html