The procedure to replace fuel tank is as follows : ----
Removal & Installation
BEHIND-THE-AXLE FUEL TANK
MIDSHIP TANK MOUNTING
Details are as follows: ----
Car repair guide?
http://technoanswers.blogspot.in/2012/03/car-repair-guide.html
Removal & Installation
BEHIND-THE-AXLE FUEL TANK
MIDSHIP TANK MOUNTING
Details are as follows: ----
Behind-the-Axle Fuel Tank
Specific to:
Ford E-150 2008-2009
Ford E-250 2008-2009
Ford E-350 Super Duty 2008-2009
- Before servicing the vehicle, refer to the Precautions Section.
- Properly relieve the fuel system pressure.
- Disconnect the negative battery cable.
- Drain any remaining fuel from the tank.
- Raise and safely support the vehicle.
- Disconnect the fuel tank filler pipe and filler vent tube from the fuel tank.
- Position a suitable jack under the fuel tank.
- Remove the fuel tank support strap retaining bolts and nuts.
- Remove the fuel tank support straps.
- Partially lower the fuel tank.
- Disconnect the fuel tubes from the fuel pump.
- Disconnect the fuel pump and fuel tank sending unit electrical connector.
- Disconnect the hose(s) from the evaporative emission valve.
- Disconnect the fuel tank pressure sensor electrical connector.
- Lower and remove the fuel tank assembly.
- Installation is the reverse order of removal.
- Tighten the support strap retaining nuts to 56-75 ft. lbs. (77-103 Nm) and support strap bolts to 64-88 ft. lbs. (87-119 Nm).
Midship Tank Mounting
Specific to:
Ford E-150 2008-2009
Ford E-250 2008-2009
Ford E-350 Super Duty 2008-2009
- Before servicing the vehicle, refer to the Precautions Section.
- Properly relieve the fuel system pressure.
- Disconnect the negative battery cable.
- Drain any remaining fuel from the tank.
- Disconnect the fuel pump/fuel sender electrical connector.
- Disconnect the fuel tank filler pipe hose.
- Disconnect the evaporative emissions (EVAP) tube connector, gasoline engines only.
- Position a suitable jack under the fuel tank.
- Remove the nut and the front fuel tank support strap.
- Remove the nut and the rear fuel tank support strap.
- Partially lower the fuel tank.
- Disconnect the fuel tube spring lock coupling. For additional information, refer to Section 310-00 .
- Disconnect the fuel tank vent tube connector., gasoline engines only.
- Lower the fuel tank.
- Installation is the reverse order of removal.
This will help.
Thanks.
FOR MORE HELP GO TO: ---
No comments:
Post a Comment