The ford E series Van Throttle body removal.
Throttle Body
REMOVAL & INSTALLATION procedure is as follows: ----
4.6L Engine
5.4L Engine
6.8L Engine
This details will help.
Thanks.
Car repair guide?
http://technoanswers.blogspot.in/2012/03/car-repair-guide.html
Throttle Body
REMOVAL & INSTALLATION procedure is as follows: ----
4.6L Engine
Specific to:
Ford E-150 2008-2009
Ford E-250 2008-2009
- Before servicing the vehicle, refer to the Precautions Section.
- Disconnect the negative battery cable.
- Remove the air intake assembly.
- Disconnect the electronic throttle control electrical connector.
- Remove the Throttle Body (TB) bolts and the TB and discard the gasket.
- Installation is the reverse order of removal. Install a new TB gasket. To install, tighten to 89 inch lbs. (10 Nm). Tighten an additional 90°.
Specific to:
Ford E-150 2008-2009
Ford E-250 2008-2009
Ford E-350 Super Duty 2008-2009
- Before servicing the vehicle, refer to the Precautions Section.
- Disconnect the negative battery cable.
- Remove the air cleaner and air cleaner intake pipe.
- Disconnect the electronic throttle control electrical connector.
- Disconnect the throttle position (TP) sensor electrical connector.
- Remove the 4 throttle body (TB) bolts and the TB and discard the TB O-ring seal.
- To install, reverse the removal procedure. Install a new TB gasket. To install, tighten to 80 inch lbs. (9 Nm) plus 90°
Specific to:
Ford E-350 Super Duty 2008-2009
- Before servicing the vehicle, refer to the Precautions Section.
- Disconnect the negative battery cable.
- Remove the air intake assembly.
- Disconnect the electronic throttle control electrical connector.
- Disconnect the TP sensor electrical connector.
- Remove the throttle body bolts and the throttle body and discard the throttle body gasket.
- Installation is the reverse order of removal. To install, tighten to 80 inch lbs. (9 Nm) plus an additional 90°.
This details will help.
Thanks.
FOR MORE HELP GO TO: ---
No comments:
Post a Comment