Dodge 5.7L Engine Cylinder head Removal?

The details for 5.7L Cylinder head replacing.

The step by step details to remove/ install cylinder head:----

1. Drain the cooling system.
2. Properly relieve the fuel system pressure.
3. Remove or disconnect the following:
   
   
   Negative battery cable

   Air cleaner resonator and ducts

   Alternator

   Closed crankcase ventilation system

   EVAP control system

   Heater hoses

   Cylinder head covers

   Intake manifold

   Rocker arms and pushrods

   Cylinder heads

To install:

NOTE

The head gaskets are not interchangeable. They are marked -L- and -R-.

 

Fig. Cylinder head torque sequence-5.7L engine

1. Install the cylinder heads. Use new gaskets and tighten the bolts, in sequence, as follows:
   1. Step 1: 12 mm bolts-25 ft. lbs. (34 Nm); 8mm bolts-15 ft. lbs. (20 Nm)
   2. Step 2: 12mm bolts-40 ft. lbs. (54 Nm); 8mm bolts retorque-15 ft. lbs. (20 Nm)
   3. Step 3: 12mm bolts-plus 90 degrees; 8mm bolts-25 ft. lbs. (34 Nm)
2. Install or connect the following:
   
   
   Rocker arms and pushrods

   Intake manifold

   Heater hoses

   Alternator

   Cylinder head covers. Torque the studs and bolts to 70 inch lbs.

   Air cleaner resonator and ducts

   Negative battery cable

These details will help.

Thanks.           

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html