@

max

Wednesday

How to Replace Fuel Pump on 2007 Dodge Caliber?

The complete procedure to replace fuel pump.

The step by step info with helpful diagrams to replace fuel pump is as follows :---


Removal & Installation



  1. Properly relieve the fuel system pressure.
  2. Remove the air cleaner housing lid and disconnect the Intake Air Temperature (IAT) sensor and make-up air hose.
  3. Remove the rear seat cushion.
  4. Remove the plastic access cover.
  5. Disconnect the electrical connector.
  6. Matchmark the orientation of the fuel pump module to the tank before removal. 
    image
    Fig. Not the fuel pump location on the top of the fuel tank.
  7. Using Special Tool 9340 Spanner Wrench, remove the left side module lock ring. 

    image
    Fig. Use a suitable spanner wrench to remove the lock ring of the fuel pump module.
  8. Pull the fuel pump module up and out of the tank.
    WARNING
    The fuel pump module will be filled fuel. Do not spill fuel inside the vehicle.
  9. Tip the fuel pump module to the side and pour any fuel back into the tank.
  10. Disconnect the internal line from the fuel pump module.
  11. Tip the module on its side again to drain any remaining fuel from the reservoir into the tank.
  12. Remove the fuel pump from the vehicle.
To install:
  1. Remove the seal from the tank opening and discard.
  2. Place a new seal between the tank threads and the pump module opening. 

    image
    Fig. Place a new seal between the tank threads and the pump module opening.
  3. Connect the internal line to the fuel pump module
  4. Install the module into the fuel tank.
  5. Reposition the fuel pump module in the tank, aligning the matchmark made earlier.
  6. While holding the fuel pump in position, install the lock ring using Special Tool 9340 Spanner Wrench.
  7. Connect the electrical connector.
  8. Install the plastic access cover.
  9. Install the rear seat cushion.
  10. Install the air cleaner housing lid and disconnect the Intake Air Temperature (IAT) sensor and make-up air hose.
  11. Connect the negative battery cable.
  12. Pressurize the fuel system with a diagnostic scan tool and check for leaks.

These details will help.
Thanks.           

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html



No comments:

Post a Comment

@