Idler Shaft Replacing on Dodge RAM?

The Idler Shaft replacing procedure.

The complete step by step details to remove idler shaft is as follows:-----

Removal & Installation

3.7L & 4.7L Engines

1. Remove the primary and secondary timing chains and sprockets.
   
   NOTE

   To remove the idler shaft, it is necessary to tap threads into the shaft, to install the removal tool.
2. Using a 12mm X 1.75 tap, cut threads in the idler shaft center bore.
3. Cover the radiator core with a suitable cover.
   
   WARNING

   Be careful when removing the idler shaft, Do not strike the radiator cooling fins with the slide hammer.
4. Using Special Tool 8517 Slide Hammer, remove the idler shaft.
5. Thoroughly clean the idler shaft bore.

To install:

1. Position the idler shaft in the bore.
   
   NOTE

   The two lubrication holes in the idler shaft do not require any special alignment.
   
   
   
   NOTE

   Before using the retaining bolt to install the idler shaft, coat the threads and the pilot on the idler shaft, with clean engine oil.
2. Using the primary idler sprocket retaining bolt and washer, carefully draw the idler shaft into the bore until fully seated.
3. Coat the idler shaft with clean engine oil.
4. Install the timing chains and sprockets. 

These details will help.

Thanks.           

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html