Oil Pan Removal on 2007 Dodge Caliber?

How to replace oil pan.
The diagrams to replace oil pan.

All this details are provided.
The complete details are for 2007 Dodge caliber car models.

The oil pan removal/ install procedure is as follows :----

1. Raise and safely support the vehicle.
2. Drain the engine oil.
3. Remove the accessory drive belt splash shield.
4. Remove the lower A/C compressor mounting bolt and remove the A/C mounting bracket.
5. Remove the oil pan mounting bolts.
6. Using a putty knife, loosen the seal around the oil pan.
   
   WARNING

   Do not use the pry points in the engine block to remove the oil pan.
7. Remove the oil pan. 
   
   
   
   Fig. Use a putty knife (1) to the loose the seal around the oil pan (2)-2.0L & 2.4L Engine

To install:

1. Clean any old gasket material from the mating surfaces.
2. Apply Mopar® Engine RTV GEN II at the front cover-to-engine block parting lines. 
   
   
   
   Fig. Apply Mopar® Engine RTV GEN II to the front cover-to-engine block parting lines(1) as shown-Oil pan installation
3. Apply a 2 mm bead of Mopar® Engine RTV GEN II around the oil pan mating surface as shown in the illustration. 
   
   
   
   Fig. Apply a 2 mm bead of Mopar® Engine RTV GEN II on the oil pan mating surface as shown-Oil pan installation
4. Install the oil pan into position and tighten the bolts as follows:
   
   
   The two long bolts to 16 ft. lbs. (22 Nm).

   All other bolts to 105 inch lbs. (12 Nm).
5. Install the oil drain plug.
6. Install the A/C compressor mounting bracket and A/C compressor lower mounting bolt.
7. Lower the vehicle.
8. Refill the engine with oil to the correct level.
9. Start the engine and check for leaks.

These details will help.

Thanks.           

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html