Relieving Fuel Pressure on Dodge Caliber?

While replacing fuel pump the pressure in the fuel line system has to be relieved/released.

The basic details to perform this is as follows :---

1. Remove the lower rear seat cushion.
2. Remove the fuel pump module cover.
3. Disconnect the electrical connector for fuel pump module.
4. Start and run the engine until it stalls.
5. Attempt to restart the engine until it will no longer run.
6. Turn the ignition key to the OFF position.
7. Disconnect the negative battery cable.
   
   NOTE

   One or more Diagnostic Trouble Codes (DTCs) may have been stored in Powertrain Control Module (PCM) memory. The scan tool must be used to erase a DTC.

These details will help.

Thanks.           

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html