The complete step by step procedure to replace Transfer case on dodge dakota.
The dodge transfer case removal procedure is as follows:---
Car repair guide?
http://technoanswers.blogspot.in/2012/03/car-repair-guide.html
The dodge transfer case removal procedure is as follows:---
NV233
- Before servicing the vehicle, refer to the precautions section.
- Shift the transfer case into 2WD.
- Raise the vehicle.
- Drain the transfer case lubricant.
- Mark the front and rear propeller shafts for alignment reference.
- Support the transmission with jack stand.
- Remove the rear crossmember and skid plate, if equipped.
- Disconnect the front and rear propeller shafts at transfer case.
- Disconnect the transfer case shift motor and mode sensor wire connectors.
- Disconnect the transfer case vent hose.
- Support the transfer case with a transmission jack.
- Secure the transfer case to the jack with chains.
- Remove the nuts attaching transfer case to the transmission.
- Pull the transfer case and jack rearward to disengage the transfer case.
- Remove the transfer case from under the vehicle.
To install:
- Mount the transfer case on a transmission jack.
- Secure the transfer case to the jack with chains.
- Position transfer case under vehicle.
- Align the transfer case and transmission shafts and install the transfer case onto the transmission.
- Install and tighten the transfer case attaching nuts to 27-34 Nm (20-25 ft. lbs.).
- Connect the vent hose.
- Connect the shift motor and mode sensor wiring connectors. Secure the wire harness to clips on the transfer case.
- Align and connect the propeller shafts.
- Fill the transfer case with the correct fluid.
- Install the rear crossmember and skid plate, if equipped. Tighten the crossmember bolts to 41 Nm (30 ft. lbs.).
- Remove the transmission jack and support stand.
- Lower the vehicle and verify transfer case shift operation.
These details will help.
Thanks.
FOR MORE HELP GO TO: ---
No comments:
Post a Comment